source: mainline/kernel/genarch/include/genarch/drivers/omap/irc.h@ c310f9b

/*
 * Copyright (c) 2012 Maurizio Lombardi
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 *
 * - Redistributions of source code must retain the above copyright
 *   notice, this list of conditions and the following disclaimer.
 * - Redistributions in binary form must reproduce the above copyright
 *   notice, this list of conditions and the following disclaimer in the
 *   documentation and/or other materials provided with the distribution.
 * - The name of the author may not be used to endorse or promote products
 *   derived from this software without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
 * IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
 * OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
 * IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
 * NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
 * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
 * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
 * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
 * THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 */
/** @addtogroup genarch
 * @{
 */

/**
 * @file
 * @brief Texas Instruments OMAP on-chip interrupt controller driver.
 */

#ifndef KERN_OMAP_IRQC_H_
#define KERN_OMAP_IRQC_H_

#include <genarch/drivers/omap/irc_regs.h>
#include <typedefs.h>

typedef struct {
        const ioport32_t revision;
#define OMAP_IRC_REV_MASK 0xFF

        const uint8_t padd0[12];

        /* This register controls the various parameters
         * of the OCP interface.
         */
        ioport32_t sysconfig;
#define OMAP_IRC_SYSCONFIG_AUTOIDLE_FLAG   (1 << 0)
#define OMAP_IRC_SYSCONFIG_SOFTRESET_FLAG  (1 << 1)

        /* This register provides status information about the module */
        const ioport32_t sysstatus;
#define OMAP_IRC_SYSSTATUS_RESET_DONE_FLAG (1 << 0)

        const uint8_t padd1[40];

        /* This register supplies the currently active IRQ interrupt number */
        ioport32_t sir_irq;
#define OMAP_IRC_SIR_IRQ_ACTIVEIRQ_MASK       0x7F
#define OMAP_IRC_SIR_IRQ_SPURIOUSIRQFLAG_MASK 0xFFFFFFF8

        /* This register supplies the currently active FIQ interrupt number */
        const ioport32_t sir_fiq;
#define OMAP_IRC_FIQ_IRQ_ACTIVEFIQ_MASK       0x7F
#define OMAP_IRC_FIQ_IRQ_SPURIOUSFIQFLAG_MASK 0xFFFFFFF8

        /* This register contains the new interrupt agreement bits */
        ioport32_t control;
#define OMAP_IRC_CONTROL_NEWIRQAGR_FLAG       (1 << 0)
#define OMAP_IRC_CONTROL_NEWFIQAGR_FLAG       (1 << 1)

        /* This register controls protection of the other registers.
         * This register can only be accessed in priviledged mode, regardless
         * of the current value of the protection bit.
         */
        ioport32_t protection;
#define OMAP_IRC_PROTECTION_FLAG              (1 << 0)

        /* This register controls the clock auto-idle for the functional
         * clock and the input synchronizers.
         */
        ioport32_t idle;
#define OMAP_IRC_IDLE_FUNCIDLE_FLAG           (1 << 0)
#define OMAP_IRC_IDLE_TURBO_FLAG              (1 << 1)

        const uint8_t padd2[12];

        /* This register supplies the currently active IRQ priority level */
        const ioport32_t irq_priority;
#define OMAP_IRC_IRQ_PRIORITY_IRQPRIORITY_MASK     0x7F
#define OMAP_IRC_IRQ_PRIORITY_SPURIOUSIRQFLAG_MASK 0xFFFFFFF8

        /* This register supplies the currently active FIQ priority level */
        const ioport32_t fiq_priority;
#define OMAP_IRC_FIQ_PRIORITY_FIQPRIORITY_MASK     0x7F
#define OMAP_IRC_FIQ_PRIORITY_SPURIOUSIRQFLAG_MASK 0xFFFFFFF8

        /* This register sets the priority threshold */
        ioport32_t threshold;
#define OMAP_IRC_THRESHOLD_PRIORITYTHRESHOLD_MASK     0xFF
#define OMAP_IRC_THRESHOLD_PRIORITYTHRESHOLD_ENABLED  0x00
#define OMAP_IRC_THRESHOLD_PRIORITYTHRESHOLD_DISABLED 0xFF

        const uint8_t padd[20];

        struct {
                /* Raw interrupt input status before masking */
                const ioport32_t itr;

                /* Interrupt mask */
                ioport32_t mir;

                /* This register is used to clear the interrupt mask bits,
                 * Write 1 clears the mask bit to 0.
                 */
                ioport32_t mir_clear;

                /* This register is used to set the interrupt mask bits,
                 * Write 1 sets the mask bit to 1.
                 */
                ioport32_t mir_set;

                /* This register is used to set the software interrupt bits,
                 * it is also used to read the current active software
                 * interrupts.
                 * Write 1 sets the software interrups bits to 1.
                 */
                ioport32_t isr_set;

                /* This register is used to clear the software interrups bits.
                 * Write 1 clears the software interrupt bits to 0.
                 */
                ioport32_t isr_clear;

                /* This register contains the IRQ status after masking. */
                const ioport32_t pending_irq;

                /* This register contains the FIQ status after masking. */
                const ioport32_t pending_fiq;
        } interrupts[4];

        /* These registers contain the priority for the interrups and
         * the FIQ/IRQ steering.
         */
        ioport32_t ilr[OMAP_IRC_IRQ_COUNT];
/* 0 = Interrupt routed to IRQ, 1 = interrupt routed to FIQ */
#define OMAP_IRC_ILR_FIQNIRQ_FLAG    (1 << 0)
#define OMAP_IRC_ILR_PRIORITY_MASK   0x3F
#define OMAP_IRC_ILR_PRIORITY_SHIFT  2

} omap_irc_regs_t;

static inline void omap_irc_init(am335x_irc_regs_t *regs)
{
        int i;

        /* Initialization sequence */

        /* 1 - Program the SYSCONFIG register: if necessary, enable the
         *     autogating by setting the AUTOIDLE bit.
         */
        regs->sysconfig &= ~OMAP_IRC_SYSCONFIG_AUTOIDLE_FLAG;

        /* 2 - Program the IDLE register: if necessary, disable functional
         *     clock autogating or enable synchronizer autogating by setting
         *     the FUNCIDLE bit or the TURBO bit accordingly.
         */
        regs->idle &= ~OMAP_IRC_IDLE_FUNCIDLE_FLAG;
        regs->idle &= ~OMAP_IRC_IDLE_TURBO_FLAG;

        /* 3 - Program ILRm register for each interrupt line: Assign a
         *     priority level and set the FIQNIRQ bit for an FIQ interrupt
         *     (by default, interrupts are mapped to IRQ and
         *     priority is 0 (highest).
         */

        for (i = 0; i < OMAP_IRC_IRQ_COUNT; ++i)
                regs->ilr[i] = 0;

        /* 4 - Program the MIRn register: Enable interrupts (by default,
         *     all interrupt lines are masked).
         */
        for (i = 0; i < 4; ++i)
                regs->interrupts[i].mir_set = 0xFFFFFFFF;
}

/** Get the currently active IRQ interrupt number
 *
 * @param regs     Pointer to the irc memory mapped registers
 *
 * @return         The active IRQ interrupt number
 */
static inline unsigned omap_irc_inum_get(am335x_irc_regs_t *regs)
{
        return regs->sir_irq & OMAP_IRC_SIR_IRQ_ACTIVEIRQ_MASK;
}

/** Reset IRQ output and enable new IRQ generation
 *
 * @param regs    Pointer to the irc memory mapped registers
 */
static inline void omap_irc_irq_ack(am335x_irc_regs_t *regs)
{
        regs->control = OMAP_IRC_CONTROL_NEWIRQAGR_FLAG;
}

/** Reset FIQ output and enable new FIQ generation
 *
 * @param regs    Pointer to the irc memory mapped registers
 */
static inline void omap_irc_fiq_ack(am335x_irc_regs_t *regs)
{
        regs->control = OMAP_IRC_CONTROL_NEWFIQAGR_FLAG;
}

/** Clear an interrupt mask bit
 *
 * @param regs    Pointer to the irc memory mapped registers
 * @param inum    The interrupt to be enabled
 */
static inline void omap_irc_enable(am335x_irc_regs_t *regs, unsigned inum)
{
        ASSERT(inum < OMAP_IRC_IRQ_COUNT);
        const unsigned set = inum / 32;
        const unsigned pos = inum % 32;
        regs->interrupts[set].mir_clear = (1 << pos);
}

/** Set an interrupt mask bit
 *
 * @param regs    Pointer to the irc memory mapped registers
 * @param inum    The interrupt to be disabled
 */
static inline void omap_irc_disable(am335x_irc_regs_t *regs, unsigned inum)
{
        ASSERT(inum < OMAP_IRC_IRQ_COUNT);
        const unsigned set = inum / 32;
        const unsigned pos = inum % 32;
        regs->interrupts[set].mir_set = (1 << pos);
}

#endif

/**
 * @}
 */