Index: kernel/genarch/src/drivers/amdm37x_uart/amdm37x_uart.c
===================================================================
--- kernel/genarch/src/drivers/amdm37x_uart/amdm37x_uart.c	(revision 8776c46e55af36d63be4369ca675764e996a105c)
+++ kernel/genarch/src/drivers/amdm37x_uart/amdm37x_uart.c	(revision 8776c46e55af36d63be4369ca675764e996a105c)
@@ -0,0 +1,163 @@
+/*
+ * Copyright (c) 2012 Jan Vesely
+ * All rights reserved.
+ *
+ * Redistribution and use in source and binary forms, with or without
+ * modification, are permitted provided that the following conditions
+ * are met:
+ *
+ * - Redistributions of source code must retain the above copyright
+ *   notice, this list of conditions and the following disclaimer.
+ * - Redistributions in binary form must reproduce the above copyright
+ *   notice, this list of conditions and the following disclaimer in the
+ *   documentation and/or other materials provided with the distribution.
+ * - The name of the author may not be used to endorse or promote products
+ *   derived from this software without specific prior written permission.
+ *
+ * THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
+ * IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
+ * OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
+ * IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
+ * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
+ * NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
+ * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
+ * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
+ * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
+ * THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+ */
+/** @addtogroup genarch
+ * @{
+ */
+/**
+ * @file
+ * @brief Texas Instruments AMDM37x on-chip uart serial line driver.
+ */
+
+#include <genarch/drivers/amdm37x_uart/amdm37x_uart.h>
+#include <ddi/device.h>
+#include <str.h>
+#include <mm/km.h>
+
+static void amdm37x_uart_txb(amdm37x_uart_t *uart, uint8_t b)
+{
+	/* Wait for buffer */
+	while (uart->regs->ssr & AMDM37x_UART_SSR_TX_FIFO_FULL_FLAG);
+	/* Write to the outgoing fifo */
+	uart->regs->thr = b;
+}
+
+static void amdm37x_uart_putchar(outdev_t *dev, wchar_t ch)
+{
+	amdm37x_uart_t *uart = dev->data;
+	if (!ascii_check(ch)) {
+		amdm37x_uart_txb(uart, U_SPECIAL);
+	} else {
+		if (ch == '\n')
+			amdm37x_uart_txb(uart, '\r');
+		amdm37x_uart_txb(uart, ch);
+	}
+}
+
+static outdev_operations_t amdm37x_uart_ops = {
+	.redraw = NULL,
+	.write = amdm37x_uart_putchar,
+};
+
+static irq_ownership_t amdm37x_uart_claim(irq_t *irq)
+{
+	return IRQ_ACCEPT;
+}
+
+static void amdm37x_uart_handler(irq_t *irq)
+{
+	amdm37x_uart_t *uart = irq->instance;
+	while ((uart->regs->rx_fifo_lvl)) {
+		const uint8_t val = uart->regs->rhr;
+		if (uart->indev && val) {
+			indev_push_character(uart->indev, val);
+		}
+	}
+}
+
+bool amdm37x_uart_init(
+    amdm37x_uart_t *uart, inr_t interrupt, uintptr_t addr, size_t size)
+{
+	ASSERT(uart);
+	uart->regs = (void *)km_map(addr, size, PAGE_NOT_CACHEABLE);
+
+	ASSERT(uart->regs);
+
+	/* See TI OMAP35X TRM ch 17.5.1.1 p. 2732 for startup routine */
+#if 0
+	/* Soft reset the port */
+	uart->regs->sysc = AMDM37x_UART_SYSC_SOFTRESET_FLAG;
+	while (!(uart->regs->syss & AMDM37x_UART_SYSS_RESETDONE_FLAG)) ;
+#endif
+
+	/* Enable access to EFR register */
+	const uint8_t lcr = uart->regs->lcr; /* Save old value */
+	uart->regs->lcr = 0xbf;              /* Sets config mode B */
+
+	/* Enable access to TCL_TLR register */
+	const bool enhanced = uart->regs->efr & AMDM37x_UART_EFR_ENH_FLAG;
+	uart->regs->efr |= AMDM37x_UART_EFR_ENH_FLAG; /* Turn on enh. */
+	uart->regs->lcr = 0x80;              /* Config mode A */
+
+	/* Set default (val 0) triggers, disable DMA enable FIFOs */
+	const bool tcl_tlr = uart->regs->mcr & AMDM37x_UART_MCR_TCR_TLR_FLAG;
+	/* Enable access to tcr and tlr registers */
+	uart->regs->mcr |= AMDM37x_UART_MCR_TCR_TLR_FLAG;
+
+	/* Enable FIFOs */
+	uart->regs->fcr = AMDM37x_UART_FCR_FIFO_EN_FLAG;
+
+	/* Eneble fine granularity for RX FIFO and set trigger level to 1,
+	 * TX FIFO, trigger level is irelevant*/
+	uart->regs->lcr = 0xbf;              /* Sets config mode B */
+	uart->regs->scr = AMDM37x_UART_SCR_RX_TRIG_GRANU1_FLAG;
+	uart->regs->tlr = 1 << AMDM37x_UART_TLR_RX_FIFO_TRIG_SHIFT;
+
+	/* Restore enhanced */
+	if (!enhanced)
+		uart->regs->efr &= ~AMDM37x_UART_EFR_ENH_FLAG;
+
+	uart->regs->lcr = 0x80;              /* Config mode A */
+	/* Restore tcl_lcr access flag*/
+	if (!tcl_tlr)
+		uart->regs->mcr &= ~AMDM37x_UART_MCR_TCR_TLR_FLAG;
+
+	/* Restore lcr */
+	uart->regs->lcr = lcr;
+
+	/* Disable interrupts */
+	uart->regs->ier = 0;
+
+	/* Setup outdev */
+	outdev_initialize("amdm37x_uart_dev", &uart->outdev, &amdm37x_uart_ops);
+	uart->outdev.data = uart;
+
+	/* Initialize IRQ */
+	irq_initialize(&uart->irq);
+	uart->irq.devno = device_assign_devno();
+	uart->irq.inr = interrupt;
+	uart->irq.claim = amdm37x_uart_claim;
+	uart->irq.handler = amdm37x_uart_handler;
+	uart->irq.instance = uart;
+
+	return true;
+}
+
+void amdm37x_uart_input_wire(amdm37x_uart_t *uart, indev_t *indev)
+{
+	ASSERT(uart);
+	/* Set indev */
+	uart->indev = indev;
+	/* Register interrupt. */
+	irq_register(&uart->irq);
+	/* Enable interrupt on receive */
+	uart->regs->ier |= AMDM37x_UART_IER_RHR_IRQ_FLAG;
+}
+
+/**
+ * @}
+ */