= Working with core files = HelenOS can now produce an ELF core file when a task crashes. While you cannot really use it yet in HelenOS directly, you can extract this core file and use it with GDB to debug the application. Note that only memory state is saved as of yet. Register state is not stored in the core file. Here we assume you are using Linux as your host system and that you run HelenOS in Qemu. First configure and build HelenOS as follows: * Load preconfigured defaults: ia32 (or amd64) * Enable options: Load disk drivers on startup, Mount /data on startup, Write core files Now we need a disk image with a FAT filesystem. Make sure it has at least 20 MB (we are using 4 kB clusters and we must have at least 4 k clusters for FAT16). {{{ $ dd if=/dev/zero of=img bs=4096 count=5000 $ losetup /dev/loop0 img $ mkdosfs -s 8 -F 16 /dev/loop0 $ losetup -d /dev/loop0 }}} Run HelenOS in Qemu now and it will mount the new filesystem on {{{/data}}} automatically. {{{ $ qemu -hda img -cdrom image.iso -boot d }}} Good. Now we can take the crashdump. If you run {{{tester fault1}}} it will save a core dump under /data. Another way is to dump a running task. Let's start Tetris, determine it's task ID using the kernel console and finally run {{{taskdump}}} on it. {{{ # tetris [press F2 to switch to another VC] # kcon kconsole> tasks ... 32 tetris.... kconsole> continue # taskdump -t 32 -c /data/coretet # unmount /data }}} The last command {{{unmount /data}}} forces all data to be written out to the block device. Exit Qemu. Now you can extract the core file, for example with the following commands (tip: save this as a shell script). {{{ #!/bin/sh mkdir /tmp/hcore mount -t vfat -o loop img /tmp/hcore cp /tmp/hcore/core* . umount /tmp/hcore rmdir /tmp/hcore chmod 644 core* }}} Now you have the file {{{coretet}}} in your HelenOS source root directory. Time to fire up GDB: {{{ $ gdb uspace/dist/app/tetris coretet }}} It will complain that register state is not present in the core file, but it will work. Also note that you may want to compile your binary with debugging symbols so that type and line number information is available to GDB... Happy debugging!